Genuine Briggs & Stratton Small Jet Carburetor Screwdriver
- Special screwdriver for installing & removing small carburetor jets.

Remove and install main jet housing on Intek V-Twin engines, Extended Life Series Model 44

Installs new primer bulb and retainer in a "snap".

For removing and installing carburetor mounting studs on engines
equipped with Torx drive intake manifolds such as the Intek V-Twin engines.

The Briggs & Stratton Power Products 1.0 kW Standby Generator comes from the factory with provisions to change the mixer jet to allow use with natural gas or liquid propane.
All that's required to make the conversion is the provided jet and this 19570 screwdriver set, Not just any screwdriver will do. The blade must be thin to fit the jet slot - approximately .040" (1 mm)
but with wide enough to reach across the jet. At the same time it cannot be too wide or it will shave the peaks off the threads of the jet cavity.
A tall order fut the 19570 screwdriver set does it all. Also makes an excellent handle for the 19442 Star bits.

For quick and easy removal of primer bulb and retainer on engines with primer bulb system.