Remove and install main jet housing on Intek V-Twin engines, Extended Life Series Model 44
For quick and easy removal of primer bulb and retainer on engines with primer bulb system.
Installs new primer bulb and retainer in a "snap".
The Briggs & Stratton Power Products 1.0 kW Standby Generator comes from the factory with provisions to change the mixer jet to allow use with natural gas or liquid propane.All that's required to make the conversion is the provided jet and this 19570 screwdriver set, Not just any screwdriver will do. The blade must be thin to fit the jet slot - approximately .040" (1 mm)but with wide enough to reach across the jet. At the same time it cannot be too wide or it will shave the peaks off the threads of the jet cavity.A tall order fut the 19570 screwdriver set does it all. Also makes an excellent handle for the 19442 Star bits.
A multifunctional tool that allows the technician to perform many tasks on the carburetor during cleaning.Installs Seats Removes Emulsion Tube Removes Seats Removes O-Rings Pilot Seats Sets Float Height
Features and Advantages-Specially formulated for carburetors and small engine parts-Superior removal of heavy, greasy soils at lower detergent conditions.-Readily biodegradable components.-Contains no phenolic compounds.-No solvent or VOC content.-Neutral pH levels present-Buffered to complex typical water mineral content levels.-Ingredients include renewable source/non-petroleum based.-Low dermal irritation
Features: 2/3 gallon tank capacityAdjustable LED digitally controlled thermostat.Stainless steel tank and housing construction.Adjustable LED digital countdown timer.Ultrasonic cleaning is based on the cavitation's effect caused by high frequency ultrasonic wave vibration signals in fluid. Microscopic bubbles are formed, and they implode violently causing the cavitation's which creates an intense scrubbing action on the surface of the item being cleaned. The bubbles are small enough to penetrate microscopic crevices, cleaning them thoroughly and consistently.Measurements:Outer dimensions-6.9” x 6.5” x 9.8”(LxWxH)Inner dimensions-4.75”x 4”x 5.9 (LxWxH)Thermostat range:32°-176° FTimer range:0-60 minutesAccessories included: Steel lid, steel mesh basket, power cord, information and instruction sheet.
Genuine Briggs & Stratton Small Jet Carburetor Screwdriver - Special screwdriver for installing & removing small carburetor jets.
For removing and installing carburetor mounting studs on engines equipped with Torx drive intake manifolds such as the Intek V-Twin engines.
Includes Walbro 500-13-1 metering lever gauge,check valve removers for WA, SDC and HDC models, check valve installers for WA, SDC and HDC models, welch plug remover and welch plug installer